Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

COM110 GPRS modem & COM1 port

Spyros Mar 26, 2018 09:24 AM

I would like to know if it is possible to connect a GPRS modem (e.g. COM110) to CR1000 COM1 or COM2 or...

I have check the modem with RS232 port & CS I/O (with SC105)  port and is working fine.

I have try with COM1 port, but no success

Wiring

Modem 15pin port                CR1000

Pin_2 (Rx) -------------------------- C1

Pin_6 (Tx) -------------------------- C2

Pin_9 (Gnd) ------------------------ G

Terri Apr 4, 2018 10:26 PM

Use DevConfig and connect to the CR1000. Make sure that the Com Ports Settings tab has both COM1 and COM2 with the Baud Rate set to the correct baud. The default for them is “0 (Not used)”. You could also use a CR1000KD to change the settings under Configure, Settings.

Spyros Apr 5, 2018 06:05 AM

Terri thanks.

There was a sertting error. I fixed it, and is working fine.

Log in or register to post/reply in the forum.