Toute la FAQ (sur un total de 1872: affichage de 421-440)
- Is there a calibration procedure for the PWS100?
- Sur un site venteux, le PWS100 est-il moins précis qu'un pluviomètre ?
- Comment peut-on obtenir une copie du logiciel de temps présent du PWS100 ?
- What does the Present Weather Viewing Software do? For example, can it save data?
- Peut-on utiliser un PWS100 pour mesurer la visibilité ? Si oui, peut-il être utilisé dans une zone de sable comme le désert du Sahara?
- Quelle est la différence entre un PWS100, un pluviomètre ou un capteur de hauteur de neige ?
- Can an HFP01SC-L provide correct running averages if the scan rate is reduced to 1 minute?
- Si Short Cut ne répertorie pas TCAV-L sur sa liste de capteurs, que faire ?
- Is it OK to have a TCAV-L connected to a datalogger using a very long cable (100 ft/30 m)?
- What are the measuring range, accuracy, and resolution of the TCAV-L?
- What might cause a 25% difference between the factory calibration and the in-situ calibration of an HFP01SC-L?
- What type of quality assurance/quality control can be performed on HFP01SC-L measurements?
- For the HFP01SC-L, is there an available acquisition program that is capable of running in PipeLineMode?
- If Short Cut does not list a heat flux plate on its sensor list, what should be done?
- Does the HFP01SC-L have to be in direct thermal contact with the surrounding soil to achieve heat flux readings?
- Can the HFP01SC-L be embedded in railroad ballast, which comprises a blend of coarse rock particles?
- If the heat flow from the inside of a wall to the outside of a wall is being measured on the outside, should the blue face or the red face of the HFP01-L touch the wall?
- If the cable of the HFP01-L gets cut, can the cable be soldered to have the sensor work normally?
- Quelle est la tension de sortie exacte du HFP01 ?
- If the speed indicator on a wind monitor stops working, is there a part that can be replaced, or does the whole unit need to be replaced?
Précédent
Suivant